"Time Attack" is an application that measures the time while driving on mountain passes. Easy to use. Just run according to the displayed message. This is a must-have app for drivers who want to improve their driving skills on mountain passes. Approx. 10,000 times of measured results are saved and can be viewed and shared. Observe the Road Traffic Law and drive safely. (Measurement points of Odawara Pikes Peak (MF Ghost)) Start/goal: Vehicle detector 190m uphill from the Odawara toll gate S1: Hakone Daikanyamaguchi (13.4km from the start point) S2: Top of Route 1 (23.0km from the start point) S3: Hakone Shindo Yamazaki Sign (37.3km from the start point, Bypass overpass) Goal/Start: "早川三丁目" Traffic Light (40.1km from the start point) (Measurement points of Ashinoko GT (MF Ghost)) Start/goal: No U-turn sign 100m from Hakonetouge Tollgate S1: Skyline Branch (Kojiri Pass) (7.8km from the start point) S2: Kojiri Heirpin (10.8km from the start point) S3: Motohakone Intersection (19.7km from the start point) Goal/Start: Hakone Pass Traffic Light (23.7km from the start point) (Measurement points of Ikaho Haruna Road (Initial D)) Start/Goal: "伊香保温泉” standing signboard of the water tower parking area S1: "伊香保リンク" signboard (2.4km from the start point) S2: "長嶺自然公園" signboard (5.8km from the start point) Goal/Start: "アルテナード" signboard (7.6km from the start point) (Measurement points of Hakone Turnpike) Start/goal: Vehicle detector 190m uphill from the Odawara toll gate S1: Crossing point with forest road Shirogane Line (3.5km from the start point) S2: Emergency shelter (6.8km from the start point) S3: Starting point of climbing lane (9.7km from the start point) Goal/Start: The standing tree of the left blockade chicane (12.5km from the start point) (How to use) 0) If you fix your iPhone to the dashboard, you can see the time while driving and use it comfortably. 1) Start the app and select the course you want to measure. Measurements can be taken from either side of the Start/Goal. 2) Tap the Start button before the starting point. It is OK to tap at a position quite far from the starting point. The Start button changes to Standby/Cancel button, and the device enters standby mode waiting for measurement to start. 3) Measurement will begin once you pass the starting point. The Standby/Cancel button changes to Stop button. 4) Run all the way to the goal. 5) The measurement ends when you pass the goal point. The Stop button changes to Next button. 6) When you tap the Next button, the Next button changes to Standby/Cancel button, and the device enters standby mode waiting for the next measurement to start. 7) When tapping Results button after exiting standby mode, all measured results will be displayed. The developer assumes no responsibility for any loss or claims by third parties which may arise from the use of this app. Time Attack - Enjoy the drive Ⓒ 2023 Takao Ichimura
